• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Just got car now knocking



I'll probably go to the exhaust shop and have them cut a slit on the bottom hole on both manifolds. I wasn't aware the studs were supposed to be tightened all the way down. Most people say finger tight
 


Ok I see where I messed up at. The stud is stocking out past the nut on mine. I don't know how I can correct my error without other than cutting the manifolds a little. I'm sure if I take a nut off the stud will spin as well breaking my thread sealant
 
43e54d9fa5a4521204799a18a193a094.jpg


Sent from my SM-G928V using Tapatalk
 


Yeah, you will break the sealant if you used liquid, and might end up with a leak if you move them now.

Sent from my SM-G930V using Tapatalk
 


Well instead of cutting the manifolds and since it's basically the bottom studs that are sticking out, could I unscrew it out of the head? And put more thread sealer on the bolt without taking everything back apart?

Sent from my SM-G928V using Tapatalk
 
You must log in or register to reply here.
Back
Top