• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

February meet at CapnBreakAlot's



My problem is the old one refuses to come off lol but sure I'll take it

I had the same problem and striped the bolt off to a circle, i ended up useing a pair of vice pliers and a breaker bar,but i was on a lift so it might be kinda hard to get leverage on floor jacks, i know i would have never got it without the lift.
 
All right...it's been confirmed that I can get up to 5 sets of 1.9 rockers.

Right now I have 3 confirmed and need to know final number by Friday before they ship. Once confirmed on Friday I'll place the order for the additional parts like spring, retainers, valve seals. Hopefully everything will be here by next Friday and should have everything at the meet.

Clay
Austin
Michael
 


They were descriped in an earlier post. They are Harland Sharp rockers (all Aluminums roller rocker) with revised pedistals. About the only thing not included is valve cover gaskets.
 


Get them kory and drive down

I'd like to man, I have so much money I'd need for this ic set up still though lol. I just bought a 3.4 setup, I'll need a tune after so that's another 200. I still need lim gaskets, lca's, sway bar, and one more helper spring for my coilovers. I'm debating it, so we'll see. Even if I could buy em n get them shipped to me by Greg if that's possible. Gotta figure out my money situation rn. I'm on measly unemployment which barely covers my bills rn lol.
 
Agreed, considering I have a 3+ hr drive one way... If it's any precipitation I might have to reconsider attending...

Sent from my Galaxy Note 3
 


I was not far from you the other day mrlogic. I was probably 30-45 minutes south of Detroit saving a buddies Regal. 75 between here and Detroit is beyond boring..
 
Back
Top