• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.


Today I checked out if the HUD works. It does. So grabbed a razor and hack saw blade. And went to town cutting a big hole in my dash!!!
HUD up and running no problems. Looks boss. Just a shame can't see with my sunglasses on LoL
 


Found this on the G6 I spent 20 hours polishing this weekend

IMAG2125.jpg


Somehow, I'm glad to see that today. Before, the water would just stay and not bead up. So this is a gorgeous sight.
Finally getting somewhere with this car's finish. yay!
 
danielle15 said:
Found this on the G6 I spent 20 hours polishing this weekend

IMAG2125.jpg


Somehow, I'm glad to see that today. Before, the water would just stay and not bead up. So this is a gorgeous sight.
Finally getting somewhere with this car's finish. yay!
Click to expand...

That is some pretty beading. I love to see that. Make me want to do my car this week.
 
the first time i used the pc on my car the water still beaded up just like that after a year, with a lot of weekly car washes.

i do it yearly now, nothing but car washes in between.
 
scottydoggs said:
the first time i used the pc on my car the water still beaded up just like that after a year, with a lot of weekly car washes.

i do it yearly now, nothing but car washes in between.
Click to expand...

The PC got a workout this weekend, that's for sure.
I just did the G6 back in March, only thing its had is a few washes since then and if its not at work outside, its in the garage. When I washed it saturday, the water just sat there. Didn't run off or bead up or anything. I was disgusted lol.
So hopefully these 3 coats of wax on top of everything else will last a little longer.

I seriously don't know how I waxed before I got the PC. That thing takes all the work out of it, so nice!
 


I put the scanner on my car today....pulled up 8 stored codes...copied the codes down then cleared the codes....still got the abs light on....took it to my uncles put the abs scanner on and it shows that the new hub isn't showing any speed...when I put the new hub on I was looking at the wires and the negative wire is showing a bit of copper....so now I have to clip that piece and butt connect it back together and hope it shows...if not gotta replace a whole section of wire..:( On a good note it rained here saturday after 2 months of no rain !!!
 
scottydoggs said:
solder your wires and use shrink tubing to seal it. (but connectors suck! not even close to being weather proof.) <== that's what she said lol
Click to expand...

I think that's what ima do....goin to just jack it up and work on it from the bottom...if not gotta go to dads an get the torque wrench so when i put the wheel back on it's torqued to spec...
 


it's not about torqueing it, it's the simple fact that when a shop does it and I need to change a flat I gotta use a dam cheater bar on it cuz they torque tf out of it and cause me a pain!!
 
Status
Not open for further replies.
Back
Top