• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.
I'll get it jacked up and pull the wheel off tomorrow and try to figure it out. I think my issues aren't as major as I thought. Also quick question for anyone who can shed some light here.. I know I probably shouldn't fully trust the boost gauge in my Regal.. But it says I get 8.8lbs of boost at the top of the gears at WOT. Does that sound right? It just seems awfully high to me for a stock car.
 


seems a bit high, i see 7 psi tops. not that i watch it much. maybe the map sensor is bad? i understand thats where it reads the boost from.

if its like 5 deg's out it will hit 8 psi.

i also have 228,000 miles on it.
 


oh i have a nice shop.. heated.. car hoist... every tool... everything ever needed in a nice 64* shop.. its just that its 3hours away....
 
had my buddy wash, wax and detail the inside of my car after fixing his car. We will clay the next time but looks Purdy good










I also took these pictures of a windshield of an old Opryland Hotel bus[circa 1960's], I thought it was pretty sweet looking.







not to bad of quality for a HTC oneV
 
topped of my rad after the jb weld repair and it failed in 5 miles or less. i think it had something to do with the humidity, it was raining out when i put it on.

so i took the rad hose off, siphoned the rad dry, moved the cross bar, and the wire harness and air filter to have better access to the crack. used 1/2 the tubes of jb weld this time, lol laid it on nice and f ing thick. so thick gravity was pissing me off. i had to play with it till it set up.
 
Scottydoggs said:
topped of my rad after the jb weld repair and it failed in 5 miles or less. i think it had something to do with the humidity, it was raining out when i put it on.

so i took the rad hose off, siphoned the rad dry, moved the cross bar, and the wire harness and air filter to have better access to the crack. used 1/2 the tubes of jb weld this time, lol laid it on nice and f ing thick. so thick gravity was pissing me off. i had to play with it till it set up.
Click to expand...

That sucks. Maybe it just wanted you to play with it until it stiffened up. Ha! Hope it holds this time.
 




Steelstick jb weld, 5 bucks at meijer or walmart. Don't buy at autozone, it's 7-8 bucks. I got to meijer n always buy the whole stock. Usually 3-4. Can never have too much!
 
Doing the GTPs valve covers today since I got a day off.. Front was easy but the rear is a pain & I think I messed up the valve cover trying to wiggle it out

I'm not really sure if I should get a new one from the junk yard or just throw this one back on


me4e8uvu.jpg

y7yby2yt.jpg

9y9e5yhu.jpg



Sent from my iPhone
 
Status
Not open for further replies.
Back
Top