• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

POST WHORINGZ THREADZ!11!!1!one

Status
Not open for further replies.
I made a Facebook account once, for about 5 minutes, then I deactivated it and never looked back.

Only reason I made it was to check out this girl who contacted me on Craigslist about some parts I had for sale. She was cute. Too bad her step-dad came with her to get the parts.
 


Lmao


To much drama on there for me and I got tried of reading everyones open about there life. Stfu and keep things to yourself you don't have to broadcast every single thing.
 
For example:
xtFv8n9.jpg
 


Below Average Joe said:
both? it does this on both sides. i was thinking maybe the rack?? i won't know until I am underneath it, but just wanted some opinions. if i can get a video of the sounds tonight i will post it tomorrow. will be hard to pick it up with my camera though.
Click to expand...

Soo....the pass axle is toast. Boot is tore apart and its just clunking around down there. This will be fixed soon.
 
ehh it's a cavalier just keep driving it lol. I found a 3" extension and a pair of needle nose pliers in my garage that I believe are your's. If you want them back pm me your address and I can send them to you or we can wait until the next time we meet up.
 
The clunking deives me insane so it will be fixed soon, but not before the GP gets its plugs and wires and the friends van gets the rear brakes changed. I wondered where the pliers went.....not sure on the extension though, but i'll take it.
 


Hmm should I do

Tie-rods, Alignment & HUB this weekend, and just do valve covers next paycheck
Or
Tie-rods, Alignment & Valve Cover Gaskets this weekend, and do HUB next paycheck

Decisions, decisions ..


Sent from my iPhone
 
Bills1997GTP said:
Hmm should I do

Tie-rods, Alignment & HUB this weekend, and just do valve covers next paycheck
Or
Tie-rods, Alignment & Valve Cover Gaskets this weekend, and do HUB next paycheck

Decisions, decisions ..


Sent from my iPhone
Click to expand...

do the hub with the tie rods, then get it aligned. the wheel can move if the hub is shot and loose throwing the alignment off.
 


Scottydoggs said:
do the hub with the tie rods, then get it aligned. the wheel can move if the hub is shot and loose throwing the alignment off.
Click to expand...

Thanks Scotty helpful as always, I didn't know the hub can throw off the alignment, Should I worry about starting an inferno tho lol


Sent from my iPhone
 
Status
Not open for further replies.
Back
Top