• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.
Gave it a bath and then a coat of Meguiar’s Cleaner/Wax. Worst part was all the little scratches I didn't know I had. Doh!!!! Maybe an oil change tomorrrow.
 


found a vac line unplugged on my wifes Venture. Can figure out where it needs to go. its on the back of the engine. I'm thinking it goes into teh valve cover but I can't seem to find it. any body got any diagrams? its a 3.4
 
Bought black paint, VHT nightshade, clear coat, 2000 grit sand paper. Also, started prepping roof rails for fresh paint. Annnd, discovered the GXP rear sway bar is the GMPP sway bar. Go me, lmao!
 
Koscoe said:
found a vac line unplugged on my wifes Venture. Can figure out where it needs to go. its on the back of the engine. I'm thinking it goes into teh valve cover but I can't seem to find it. any body got any diagrams? its a 3.4
Click to expand...

Take a pic I might be able to tell you.
 
Installed a temporary radio. Might become permanent. Doing a 250 mile drive tomorrow. Ooh rah! The only place a Grand prix gets decent miles, the highway. :p
 


New plugs/wires, re-installed oxygen sensor on rear mani, made a new intake, cleaned maf and iat sensors, replaced valve cover gasket on buddies altima.

322949_4022815927092_798134732_o.jpg
 
Changed the icm on my moms car and and that cleared one misfire. It was rapid missing now its slow missing closer to WOT which I believe is fuel so a bottle of injector cleaner went in.

Sent from my Galaxy Nexus using Tapatalk 2
 


Noticed that my clear coat is flaking. Lucky me. About to go out and do some soldering for my headlight install and put in new side signal bulbs.
 


Picked up the GP from the shop. They re-did the realignment, adding some shims. No charge! But I don't know how long this alignment will last. It's not like I'm flying over speed humps, just pull into the occasional driveway to turn around. Now it feels like I'm delivering newspapers in the car that I have to pay off the bills to fix it.
 
Had the car a week now and finally got to Vacuum, wash, wax, and check the fluids. Runs great but I still smell a hint of anti-freeze once I shut her down. Don't see any leaks so I guess I'll have the system pressure tested.

IMG_3848.jpg


IMG_3845.jpg
 
Status
Not open for further replies.
Back
Top