• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.
I have been looking around a 200mi radius around me. I found a GTP for $2200, but it is too much. It has 165k. I really don't want to go any higher then $1500
 


Koscoe said:
I have been looking around a 200mi radius around me. I found a GTP for $2200, but it is too much. It has 165k. I really don't want to go any higher then $1500
Click to expand...

Show up with 1500 in hand. Walk around the car, look at body lines etc etc, and you can work that down so hard. Let him see the money, then put it in your pocket, and boom.
 
i'm ok. I have never replaced the intake gaskets, but it doesn't seem too hard, plus there are people in here that will help if I need it. I'm not quite sure if i have all of the tools to do the Lim though.
 


Koscoe said:
I don't have a torque wrench or a quick disconnect tool. Guy wants $2000 for it. It is almost 3 hours away. Not too sure if I want to drive that far for the guy to tell me no.

98 grand prix GTP
Click to expand...

torque wrench you can rent for free, its just a deposit. fuel line tool is 10 bucks, not sure if you really need it, tho, i think you can just pop the rail and sling it to the side. id rather just take it off.
 


Koscoe said:
I don't have a torque wrench or a quick disconnect tool. Guy wants $2000 for it. It is almost 3 hours away. Not too sure if I want to drive that far for the guy to tell me no. 98 grand prix GTP
Click to expand...
A Torque wrench is a good tool to have, don't rent one, just buy one. You don't need to spend a lot and buy a fancy brand, a craftsman(probably even a harbor freight) will do fine.Fuel quick disconnect tool is cheap, $3-10 maybe. You don't even need it necessarily, I disconnected mine with a pair of screwdrivers when I had an o-ring go bad while I was out of town.
 


Status
Not open for further replies.
Back
Top