• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your car today? Vol 2.0



Re: What did you do to your Car today? Vol 2.0

Toro weedeater? :th_scratchhead: No idea but I'm not sure how you could ever talk smack about my welds...:rolleyes:
 
Re: What did you do to your Car today? Vol 2.0

not my welds. just my measurements. and the one you think is real ugly is the cut off drive shaft, i even looked at it hard like wtf is that?

its the deck off a old little wonder 10 hp push blower.


not one of them welds was cleaned up, just tacked up at this point. welds still not cleaned up. it just needs to last as long as the tranny swap, then will likely be cut back apart.

011_zps5vgcd6g4.jpg~original
 
Re: What did you do to your Car today? Vol 2.0

Just messin' with ya, at ease soldier. Welds look good from my house.
 


Re: What did you do to your Car today? Vol 2.0

Well crap day today, took off my stock spoiler to clean it up and buy a slp gen 2 found it rusty and chipping paint so i wanted to wait. Then my tablet slid off the rear window into the hinge and crunch. What a **** day.
0d5981ea654205cc74541d070d8bcf31.jpg

d931709460d266eace7af4a9988cfe41.jpg

cc4d97e238d2d7e401f9d73a8fa87914.jpg


5d28df521ac7dc26dc197fd48c235967.jpg

634ab641380e32eebb5ba48df0a14062.jpg
 
Re: What did you do to your Car today? Vol 2.0

almost as bad as my day, FORDS i tell ya. rust every where, to drop the tranny you need the exhaust Y pipe off, 2 cats, one res all in one, 4 o2 sensors. fought getting them nuts off cut the cat back bolts off.

then went for the cross member and snapped a bolt off on each side on the bottom, but the 2 bolts on each inside cross member to the frame came out easy. so we need to break them last 2 bolts, cause it looks like they will, then start to actually get a tranny out tomorrow.

i think my friend is thinking of welding the cross member back up on the bottom. :th_scratchhead: he kept saying im not worried about them bolts..lol
 
Re: What did you do to your Car today? Vol 2.0

Have been polishing up my 02 Camaro SS and my polisher bit the dust yesterday. I have only used it on 4 cars. This would have been the 5th. It's plagued with the dreaded power cord issue. Meguiar's had the same issue on their previous machine. It will be going back under warranty.

[video=vimeo;138366680]http://vimeo.com/138366680[/video]
 
Re: What did you do to your Car today? Vol 2.0

Replaced GTP fuel filter, improved headlight clarity and aim by using buffy stuff and Dremel tool.
 
Re: What did you do to your Car today? Vol 2.0

Changed the rear upper ball joints on an 05 Sebring today. Had to drop the rear suspension completely to get the control arms out, yet another stupid design from Chrysler. Rear ball joints in general, WTF?
 


Re: What did you do to your Car today? Vol 2.0

Amen to that! Some joker just tried to take out the big Ponch... right on red with no stop just like the car ahead of them... with me in the outside lane going 40, RIGHT there. Its only a matter of time. smh
 
Re: What did you do to your Car today? Vol 2.0

Installed led kit inside. Right muffler is rusting out and sounds like total crap. Thought it was just the exhaust leak on the muffler so jb weld patched it and all my exhaust leaks still sounds like crap

Sent from my SM-S820L using Tapatalk
 
Re: What did you do to your Car today? Vol 2.0

Amen to that! Some joker just tried to take out the big Ponch... right on red with no stop just like the car ahead of them... with me in the outside lane going 40, RIGHT there. Its only a matter of time. smh

Im glad he didnt hut you thats the last thing you need right now. I sware the cleaner the car the bigger the target. When my dad drives the 41 Cadillac it almost gets in a wreck 2 times a day.
 
Re: What did you do to your Car today? Vol 2.0

You ain't kiddin Eric.

People sometimes run into what they are looking at because they are looking at it. At least I'm video-ing all of it now. After that close call in the GP, I had the GTP out... theres a double right turn lane at an off ramp, I was in the outside lane next to another car... but when we turned right they went for my lane. Turned their car right in front of me broadside headed into my lane, missing it by less than a foot with me stompin brake. I tell ya, I want a horse and some woods screw this!

GTP wash job, add gas to GP is my work limit today. The TP does want fresh oil too though. Might clean up the garage some.
 
Re: What did you do to your Car today? Vol 2.0

Found out I am getting new plates for it. Went to the store and when I went to put my buggy back found that someone had cut the corner of my license plate off to steal the sticker.

Funny thing is, the sticker dies the end of this month.
 


Re: What did you do to your Car today? Vol 2.0

Found out I am getting new plates for it. Went to the store and when I went to put my buggy back found that someone had cut the corner of my license plate off to steal the sticker.

Funny thing is, the sticker dies the end of this month.

I've never heard of anything like this. It's so stupid, I have nothing to say.
 
Re: What did you do to your Car today? Vol 2.0

Got one of the motor mounts on, dented the pan a bit. I was trying to push the motor on to the mount. I told my grandpa to jack it up a little so he does almost a full pump then i hear bending pan.
bc015f9f5597c60cfdb94ab2311a1a36.jpg

45a46a413fde599f192e057297cbbcce.jpg
 
Back
Top