• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Some more top swap questions! Yay!

Not tuning for methanol is one strategy some people follow because in the event of a methanol pump failure your afr is still the same
 


Do we put copper spray on a felpro head gasket? What thread locker should i use on the head bolts?

Sent from my LG-D851 using Tapatalk
 


Ok i just didnt know if the stuff on the bolts was good enough. There isnt anything else i need to know about the head gasket is there? Rtv in the corners or anything?

Sent from my LG-D851 using Tapatalk
 
i did the copper spray on both sides of the felpro head gaskets.

make sure you clean the head bolt threads with a thread chaser.
 




Theres supposed to be 3???!!... Haha i got it but these are the right ones? I still need to get washers they only had little baby ones at the store. Also i got my dads puller but he has the recessed fitting on it instead of the cone shaped one is that a problem?

Sent from my LG-D851 using Tapatalk
 
I shall do that once i get home ill take a pic of my puller in a little but i already fit it and the bolts slip through i did get the baby washers and they kinda fit but only if you angle perfect cause if the washer goes in even slightly off center then itll slip through too

Sent from my LG-D851 using Tapatalk
 
You must log in or register to reply here.
Back
Top