• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Sealer or Gasket on S/C

SnowDrift

SnowDrift

New member
I understand there are three parts I'll have to reseal since I'm removing the snout to replace the coupler.

1) Snout to rotor housing

2) Rotor housing to S/C body

Are there any gaskets at all, or do I just use the sealer Chris sells on rollingperformance.com?

Any loctite to be used anywhere? I seem to recall someone saying that in something I read about this project at some point.
 


Just use a very very thin, small amount of the sealer Chris sells. The surfaces are nearly perfectly machined and you'll squeeze almost everythig you put in there, right back out.
 
go to napa and get anaerobic sealer. Jeez bill you tell me now lol. I put quite a bit of sealer on it and it made a huge mess when i torqued it down. It's very sticky to clean up to.
 
You must log in or register to reply here.
Back
Top