• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Replacing Needle Bearings

gtpeddie

gtpeddie

New member
I have an extra gen 3 that was on my car and the needle bearings are bad i want to replace them, no scense having a bad blower laying hear might as well fix it. anyone ever replace these? need some advice on how to remove the old ones.
 


I think you have to drill and tap the holes and thread in a grease zerk and push it out with a grease gun but i could be mistaken.
 
To swap out bearings in an SC. Either follow the directions at RollingPerformance.com or see below

Get this crap
yeah001.jpg


Drill and tap the holes wtih red in them in this pic. (Gen 3 M90)
yeah006.jpg


Thread NPT pipe in and then put nut on, and screw your grease gun into the pipe/coupler
yeah003.jpg

yeah002.jpg


Squeeze until bearing pops out.
yeah007.jpg


Wipe out grease and press in new bearings.
 


You must log in or register to reply here.
Back
Top