• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Pics of my engine tear down dial up user beware

vss is hooked up oil presure is hooked up and i am at a loss i have 4 people under it we have a 04 impala as a shop car ill look under it as well
 


Is there a power steering pressure switch down there somewhere? I think I remember the green one being plugged into something related to the power steering.
 
Hidden Sensor. Sounds like a familiar problem. It does go on the RH side. Somewhere near the end of the transaxle im thinking, could be wrong.
 
Ok we found it it was the knock sensor but the conector got stuck between trans and engine and the color wasnt right now all we have is a cam pos sensor problem cam circuit low referance i changed the sensor today no luck im hoping its something easy like a ground or something no luck yet did drive it home though
 
It read low input on the sensor? Couuld be bad conection. One of my knock sensors did that for a while. It wasn't connected properly.
 


I was gonna say...either the knock sensor...but the oil pressure plug is a green color.

Good to hear you got it done man. Can't wait to get mine finished :D
 
Yea i just hate electrical crap i have to go in and test all the conections and so on its a bit%$ She ran though didnt get in it to much with the sensor problem it also seems to have a nasty shake im hoping its cause the cam problem
 
hope you get it figured out...this is like a good book just cant stop reading it lol....i to am in the middle of a build but im taking mine really slow lol eta = spring time...i to am getting lots of pics good job man.
 
final Vid & Pics of my engine tear down dial up user beware

yea pics are great specially when you can seem to place a bracket or wire or something
I was thinking about my cam sensor problem it might just be the ground im using its grounded to the hed im going to rewire it and see hopefully it will fix the issue
 
Last edited:


Yea that just started as in on that start up Its also cold as as a witches teet outside

I plan on checking it over the next week and getting better vid
Suprised no coment on my rigged vac lines lol
 
In all honesty all it takes is the willingness to try and a little ability to work with your hands
unfortunatly My diagnostic abilitys arent the best yet lol
 


You must log in or register to reply here.
Back
Top