• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

MAP Sensor problems on Swap

S

SgtCebo

New member
Just wondering how to connect a L67 MAP sensor to a GT wire set? The gtp one uses 3 wires and the gt one uses 2. Can i leave a wire out or just run 2 to 1?
 


You sure its the right sensor? Mine hooked right up, except i needed an extension because the L67 map sensor is behind the SC whereas the GT is in front.
 
JoRoW99 said:
You sure its the right sensor? Mine hooked right up, except i needed an extension because the L67 map sensor is behind the SC whereas the GT is in front.
Click to expand...

Ya its the right one. i just bought one from autozone. the only MAP sensor has 2 wires and went on top of the plastic intake. theirs no plug for this anywhere

Heres the difference.
2
is the L67

2
is the L36
 
Last edited:
matt5112 said:
I have an L36 and L67 MAP, they both use three pins.

Just slightly different connectors.
Click to expand...

Well mines just a POS then cause one the old sensor has 2 and the gtp sensor i have has 3. i do have the connector that i cut off a gtp at a junk yard. but theirs 3 wires where as the one i have on the car has 2.
 




You must log in or register to reply here.
Back
Top