• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

How Much should a 3" produce

Rudd97gtp

Rudd97gtp

New member
I have just bought this car and it has a 3" pulley. I just installed a boost gauge and it reads 10 psi at wot. Should It make more? I will put the list of wht was said to be done to the car.
 


Upgrades
-Ported supercharger with 3.0" and 3.2" pulleys
-ZZP Modular Pulley System
-Ported lower intake manifold
-ZZP Stage 1 throttle body
-Hydraulic Roller Lifters By Competition Cams
-Hi-Tech Push Rods By Competition Cams
-1.9 ratio modified rockers
-Custom air intake with K&N filter
-NGK Iridium spark plugs
-Specially mounted ZZP 1.0 Tuned PCM
-Rebuilt ZZP transmission with 3.29 Gears, Single Chain, All hard parts upgraded
-2500 Stall ZZP torque converter
-Alternator Voltage Booster
-ZZP Alternator Re-wire
-ZZP Fuel Pump Re-wire
-TOG Headers
-ZZP 3" downpipe
-Magnaflow converter
-Resonator removed and 3" pipe back to the stock mufflers
-Front and rear stabilizer bars
-Shortened dogbones
-KYB GR2 struts
-SSC lowering springs - 1.2" front and rear
-Anti-pogo washers
-New top strut plates
-HID Headlamps and Foglamps
-Aftermarket blacked out headlamp assemblies
-11" front rotors
-Other various upgrades that I am sure I am forgetting!
 


Ah, I'd venture to guess your gauge is defective.

Hookered meaning opened up too much.

If you're not seeing KR, your AFR is in the low 11's and you're running at least 15* of timing, I wouldn't worry about it.
 


Ok it has just a cheap boost gauge and I got a aeroforce gauge ;-) but didn't really kno what to look for I had it on kr and o the whole time
I think the boost gauge is messed up Cause the aeroforce is showing -9
On manifold psi and the vac gauge is showing 28-30
 
Arf is?? And I need to look for the timing to be at 15*. I am new to all the numbers of all this. But I think the timing said 23 or something
 
Lmao, I'm actually surprised the gurus here didn't tell you that u need more mods to run that small of a pulley!

Sent using my bionic thumbs from my sweet DROID Razr Maxx
 
have the aero set to KR and map then go for a nice series of second gear pulls.

See if you see any KR and what the aero says your boost is.

Then change the KR or boost to timing advance and see what thats like while going full throttle.

AFR is your air to fuel ratio.

With a ZZP PCM I'd think it'd be setup to run nicely.
 


you might be lucky. most people cant get away with that pulley on a rocker setup with no headers.

run it hard, you've got a good setup.
 
Edited to change my attitude:

You should pull the plugs and see wat they look like.

Sent using my bionic thumbs from my sweet DROID Razr Maxx
 
Last edited:
You must log in or register to reply here.
Back
Top