• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

HID Help

tyv193

tyv193

New member
Ive searched on the forum and google and can't figure out how to wire this kit. Its probably something simple but I have never done anything like this.

HID.jpg


The plug that is coming from the bulb that has no where to hook into, where does that go? Not the blue piece that goes in to the stock plug but the other one. And also where does the blue piece that is on the harness where does that plug into? Thanks.
 


are you talking about the one with the yellow on it?. if so you wont use it because of your relay harness
 


where does it plug into and where do you wire the two wires coming from it? its not the same as the blue one at the bottom of the picture. the one like like the one at the bottom is not visible.
 
also the wires that run to the battery the connector on the end is too small to fit?? am i doing it right
 
that other blue plug should go to the factory connector..can you try and get a better pic of it?...and my battery connectors were to small too, i cut it and pulled it apart to make it work
 


This is the connector im talking about in a close up

hid2.jpg


but this is a little different than the other two blue connectors. there is one that goes to the drivers side headlight that is connected. This is near the passenger side light near the wires that would connect to the battery. In the picture i have the other blue connector already plugged into the light.
hid3.jpg
 


nice, post a pic after, i wanna see 6000k, i bought 10,000k for some reason( stupid mistake) but they look like 8000k.
 
You must log in or register to reply here.
Back
Top