• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Engine Issue/Noise.. w/Vid ::SOLVED::



Dealership.
Pan $117
Pickup tube $20
P.tube gasket $2.00
New engine mount bracket $10
Engine sealant $9

Also did a rear cover gasket and rear main seal at the same time.

Sent from my SPH-L710 using Tapatalk 2
 
Last edited:
yge2eme3.jpg


ere2uzy8.jpg


Couple pics of the bigger filter and clearance.

Sent from my SPH-L710 using Tapatalk 2
 


sanuryqy.jpg


Finished up few hours ago. Had Christmas parties and Black ops2 that took up some time. Here's a finished shot for now. Next is a proper intake, 3.6mps, and a few gauges.


Sent from my SPH-L710 using Tapatalk 2
 
It's sad about the bolt. Since it's easy..you wanna couple? I've got plenty sitting in the parts bins.

FWIW, I'd go on car-part.com for a pan if you had the time.
 
I found a replacement that was identical just only a grade 8.8 vs the oem 10.9

I'll get a new one from the dealer and if my starter ever fails ill put the new one in but I had a buddy lose all 3 and used the bolt I got for his GTP and he's got quite a bit more power

Sent from my SPH-L710 using Tapatalk 2
 
Cars falling on its face above 2k rpm. I'm throwing a p1347 this should be fun. No issues before so I'm hoping for a connection issue.

Sent from my SPH-L710 using Tapatalk 2
 


All I did was put dielectric grease on all the underhood connectors. I've printed up a schematic and diagnostic flow chart. I'm hoping it's wiring and not the icm.

Sent from my SPH-L710 using Tapatalk 2
 
Found it. Broken wire between icm and pcm. Actually found it broken at the connector above the left dogbone. Not sure how it happened but runs great now that I fixed it


Sent from my SPH-L710 using Tapatalk 2
 
7y8aqage.jpg


Previous owners remote start was connected right there at one time.. Smart how close it was soldered to the connector.

Sent from my SPH-L710 using Tapatalk 2
 
Last edited:
Want a new pin? LOL I've pulled pins to replace that one before. Really irks me too. You know why, that installer was lazy and didn't want to undo the tape on the loom.
 


You must log in or register to reply here.
Back
Top