• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

EGR delete



You'll need egr block off plates. You can easily make your own. You need one where the egr goes into the LIM and one where it is on the exhaust.
 
use the tabs that are on the EGR tubes. cut them off, fill holes with anything of your choosing, bolt back onto the LIM/rear header.
 
Block holes off with two pennies and RTV them to the LIM/header bracket.

Let them dry, bolt them back on...done and done.
 
Here's what I did.

Just cut the stock flange off the EGR.
2012-05-22_20-46-54_237.jpg


Cut a piece out of a chunk of stainless pipe and shaped it to fit the opening.
2012-05-22_20-54-05_386.jpg


2012-05-22_21-34-41_38.jpg


And welded it up.
2012-05-22_21-43-15_116.jpg


I also installed it with some RTV because I don't think it will seal if you don't.
2012-05-22_21-46-58_205.jpg
 


Last edited:


If you are the tuner or whoever the tuner is, take a look at the tune and figure out why they all came on.

Make sure you/they turned the codes off the correct way. Also double check the wires and make sure they didnt get melted or grounded onto something.
 
Fivefingerdeathpunch said:
If you are the tuner or whoever the tuner is, take a look at the tune and figure out why they all came on.

Make sure you/they turned the codes off the correct way. Also double check the wires and make sure they didnt get melted or grounded onto something.
Click to expand...

Thanks for the info. I'll be on that this weekend.
 
You must log in or register to reply here.
Back
Top