• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

98GTPVet progress slow build




not good eally leaky bottom oil n trans pan next with poly lower engine mount is next check

its all naked now w time to put to put new parts on
 
new parts oh yea hub rotor pads and inner and outer tie rods but i did take out my ledt inner tie rod and a butt load of liquid came out, bad rack n pinion maybe? oh well
 



got her on the alignment rack

damn son my **** was way off i wasnth able to adjust right rear toe since the bar wouldnth move what is the name of that bar to adjust toe

and i couldnth resist taking a picture of dat A S S Now after worked i went ahead and did a couple runs with a friend of mine who drives a 09 cobalt SS nothing dangerous just 30-60 runs and 0-60 runs dat it and his shet was quick idk could i be a whole lot slower cuz of my engine mounts? and well more to come
 
oh yea my lower ball joints are riveted in sooooo FACK that imjust return my new lower ball joints and get full lower control arms from rockauto
 
looks like rims will come later later gotta get my mounts and maybe some other stuff bought my wifes dads civic for 250 bucks running and good and i allready have a buyer this saturday coming up for 1500 so we will see haha
 


f**k it get one for the driveway too haha. and my rear tie rods were seized up too when I did an alignment on my car.
 
oops my bad. when i bought them from carquest over the phone i said tie rods and the right parts came! haha maybe i just ended up talking to a smart guy.
 


ok thanks guys couple of questions if yall can answer maybe some tips and trick to replace bottom engine mount and oil pan gasket ??? also i have found aome good wheels 5x4.5 same as 5x114.3 the hub bore is 73.1 will that be a perfect fit or what and will anything from a hub bore from 70-73 fit?
 
I run a 5x114.3 wheel with a 73.1mm hub bore no issues. But i also use hubcentric rings.

The stock size is 5x115 but 5x114.3 works, i recommend using hubcentric rings to match our hubsize which is 70.3mm. I got mine for 8 bucks on amazon and they were aluminum too.

Sent from BFE
 
Last edited:
This video explains how to remove the oil pan. if you do this you should be able to get the motor mount out too.

 
You must log in or register to reply here.
Back
Top