BillBoost37

if i run a straight wire from the pink wire at my maf to the fuse box.. you think that ign1 fuse would stop blowing?

Lil mike is my middle name work lil in front of it... Nd i will pull thru lol just thought im on here why not ask

Hey Bill, i received the injectors were iin great shape.

thanks again.

-Javi

Enfield Ct. Depending on where you are in NY, it may be far or not very far.

hey bill. where are you located? i am in florida but live in new york. may need you to do some work on my car

Will do Bill. Talk soon man

hey John.. shoot me a text. Lost my phone and many contacts. Good to hear from you.

Aye Bill, It's John with the black 05 GP. You helped me with my wiring issue late Aug, early Sept last year. Just wanted to give you a shout and say hey. How are things man? Hope all is well. Keep in touch. We will have to connect at some point and drink a cold beverage. Take care

Yes..It's a settting

hey do you know how to change the dhp values from Celsuis to Farenheight?

i tore down the car the lim was toast pix in the runnin hot thread

thank you sir, had me thinking it could be a bigger issue but yeah ill get back to ya, thanks dr boost lmao

Check fuel pressure, clean the maf and call me in the morning.

hey bill, when i got to start my car when its still warm every once in a while its just seems like it starts like ****. just rough but just for sec

ok, thank you for your help
Red

Red, If you are reading with a Modis, then likely you understand that the maf sensor can cause issues. Try unplugging it and lettting it learn. I'd think it's either the wiring to the maf or the maf itself.

On vacuum.. yes, replace the vac lines
There is a tube that goes from the EGR to the LIM. Pull it and pull back the piece that holds it to the LIM. Look close at the edge, likely it's cracked. Replace that and most of your vac leaks should be all set.

If you continue to get the code, follow the trouble chart in the Modis. It should give you the electrical diagram etc to follow/test things.

i was wondering if you had any ideas,
i have a 1997 gp gtp
i gutted the cat, removed the resignater, removed the mufflers
I removed the airbox/tube and put a cone on the throttle body
180 deg thermostat
replaced the LIM gaskets and all above it
replaced plugs and wires
when the car gets warm it will cut out and right back in, its pretty ruff, the motis shows MAF low signal, it was showing MAF low sig, MAP low sig, and left bank running lean (what you told me makes sence about having the single exhaust and o2 sensor im just saying what the motis reads)
i did clean the MAF when i had it off with the MAF cleaner
i do know that a lot of the vac lines must be cracked because whoever had it before me has electrical tape on all the lines, i am going tonight to get all T and lines, i was wondering if you had any ideas on what my problem might be?
Any help is appreciated
thanks
Red

Bill, you are The Man. i'm gonna do the job 2morrow. u gave me the best news this week. thank you and i'll probably post pics.

You can do it topside. Act like a motor pull except drain both trans fluid and oil, pull the axles like you would for a trans. Disconnect the electrical for the engine and the trans. Then using a leveler lift it out and get the trans mount off, then with the passenger side start putting that end to the roof and you'll be able to squeak past the master cylinder. It may help to have another person over there and unbolt the master (leave the lines connected...but allow it to move a bit, giving you more room.