• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.
Rockers are done, it seems to pull a bit harder, there was some noise from the rear but it seems to have fixed itself. Probably just needed to oil up a bit. We'll see. Pulls a bit harder too, so that's nice. I really want that pulley drop now. I have more pics in my build thread, but here's the stock arms after 10k, still pretty clean IMO.

She's dusty, but pretty. The dust is a proctective coating. I need a new (clean) coolant tank too:
 


Booba5185 said:
Rockers are done, it seems to pull a bit harder, there was some noise from the rear but it seems to have fixed itself. Probably just needed to oil up a bit. We'll see. Pulls a bit harder too, so that's nice. I really want that pulley drop now. I have more pics in my build thread, but here's the stock arms after 10k, still pretty clean IMO.

She's dusty, but pretty. The dust is a proctective coating. I need a new (clean) coolant tank too:
Click to expand...
What rockers did you install?
 
There's been a few places I've seen recently that have said they make the push rods rub the head's casting. There's a thread around here somewhere on it...
 


I would say just run ERs vs 1.8s, you get 1.85 on one set of valves, I felt like I had better gains with the 1.85 on exhaust than intake, opposite of an NA setup because the supercharger can force the intake side.. just need a bit more exhaust flow. Just my $.02
 


Booba5185 said:
There's been a few places I've seen recently that have said they make the push rods rub the head's casting. There's a thread around here somewhere on it...
Click to expand...

I've had mine on for over 2 years now, so far so good....for now. I just checked ZZP`s website, I guess they`re keeping quiet, there`s nothing noted about it.
 
New strut and spring on the cavy this weekend. No more bounce.......

New fuel line on the ATV project. Still not getting gas, so took the carb off and will clean it when I find some time. Poured some gas in the head and it ran for about 3 sec or so.
 
That's great Joe!

I emptied out the backseat a bit. Still too much in there from the move and working on one of the houses. Was nice to see the seat again.
 
Tried to get the fuel filter off the cavy too. Not enough space and too rusted. Still chasing the miss. Gong to call my mechanic and have them look at it and the trans leak. Not feasible to sell cavy and purchase cheap w-body.
 


Status
Not open for further replies.
Back
Top