TimMcCallum
Banned
I found a couple cut wires
P1350 Code
- Thread starter TimMcCallum
- Start date
TimMcCallum
Banned
I used connectors and heat shrink and tape. I dont know if I just ripped them or what. I think I just did it. So it wont fix anything haha. Ill let ya know in like 10 mins
Scottydoggs
Killa Bee
that way will fail over time, solder for the long haul.
BillBoost37
New member
ScottyD, He can't hear you, He selectively reads, and I'm fairly sure he doesn't believe in quality work standards.
DH Scott summed it up pretty well
DH Scott summed it up pretty well
TimMcCallum
Banned
It seems to be that it is fine. Getting it scanned later
TimMcCallum
Banned
I plan on soldering it just ran out last night and needed the car for work today
Below Average Joe
New member
It takes a whole 30 seconds to solder wires together and heat shrink them? Lazy
TimMcCallum
Banned
Because it was 12 last night that I did all this and wasnt going to the store when I had to be up for work at 5.
BillBoost37
New member
System says you posted it was done at 11
TimMcCallum
Banned
I was doing all the connecters and stuff around 11:30 and didnt have it all put back together till around 12
BillBoost37
New member
Do you have proof?
TimMcCallum
Banned
Proof of?
TimMcCallum
Banned
Quick question. Does oil by any chance go threw or around the throttle body? The gen V adapter plate vacuum nipple is slowly leaking oil out of it seems. Directly onto the cross over and its very annoying. Thx
Scottydoggs
Killa Bee
it has coolant that would flow to the tb.
open your tb flap and see if its all wet inside with oil, if it is all wet theres a issue for sure.
open your tb flap and see if its all wet inside with oil, if it is all wet theres a issue for sure.
TimMcCallum
Banned
Its dripping out by the nipple onto the exhaust and top of tranny
BillBoost37
New member
Nope, no oil.
TimMcCallum
Banned
Kinda ****ty pic I took like last week
TimMcCallum
Banned
Another issue to find out tonight.
Scottydoggs
Killa Bee
that green stuff in dots? is that the leak? its coolant.
take the tb off and re do all the gaskets. look for a crack in the spacer.
take the tb off and re do all the gaskets. look for a crack in the spacer.
TimMcCallum
Banned
Its not coolant. Its oil