• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

ZZP Oil Pans



The thread pitch/size is different from the plug they sell, I cannot answer the other part of your question though.
 
Ok. The reason i asked was because i wanted to replace my oil pan on my motor....but still debating if i should. It just has a small ding on the bottom right but everything else is still good. I was thinking i should just clean everything up and repaint it and change the gasket. Any suggestions?


20121203_130401.jpg
 
Mine is smashed in on the bottom, I also was planning on replacing it, but then decided who cares. No one will ever see it, and it doesn't leak.
 


I have taken a 4x4 or other block of wood and pounded a pan or three out while they were off the engine. It's all good.
 
I dont think it requires RTV but i like putting a even amount of Black RTV on the gasket itself just make sure you clean the pan and block where the pan bolts up to well, clean all the oil and dirt of it just did mine last week.
 


You must log in or register to reply here.
Back
Top