• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

ZZP logs hitting blower casing bolt after SS IC instal

01gpgt01

01gpgt01

New member
BolthittingrailnotlettingLogsseal.jpg picture by onequickfamilysedan - Photobucket

WTF? I ran it for a week after installing the SSIC. I didnt notice the log was hitting the blower bolt and not letting the injector closest to the egr valve not fully seat. I only noticed when I pulled the Log off to reseal the FPR. :th_nervous: Im so lucky the car didnt go up in flames.....


This picture shows the injector not fully seated and crooked as im trying to force it in. Hard to tell in the pic but the greyish figure is the injector that's to the left a little off center.(pic taken at egr) POS LOGS HITTING BLOWER BOLT picture by onequickfamilysedan - Photobucket
 
Last edited:


Interesting. I have an SSIC I'm going to be installing but I also have ZZP's new design billet rails so that might make a difference.
 
You must log in or register to reply here.
Back
Top