• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Where can i wire this to?

jayroca

jayroca

Banned
Tryna figure where i can wire these 2 wires in my car for the heated seat switch its a plug missing to hook to this plug:

36bde8106a88b5b47cf3f95c9727c86d.jpg


My GTP didnt come wit heated seats so im adding this fucntion/mod can i splice into my new seats which are heated which has the 2 blue and pink plugs i need? Thanks
 


my guess is your at the junk yard? if so take that cars harness follow it to where ever it goes. take as much of it as you can.
 
BillBoost37 said:
What are you expecting from pink and blue?
Click to expand...
Bill i believe its suppossed to make the heated seats to work i plugged the whole harness and that plugs left so basically it something from my car heated seat harness is added from my stock harness

And scotty thats my car lol
 
Last edited:
That plug in your picture has nothing to do with the heated seats. Nothing. I've installed heated seats and original harnesses from other cars many times.

Nothing

BTW.. clean your shifter surround while it's apart.
 


swipe some transmission side cover bolts for me or ill swipe some off the one at your house lol!!! then i can throw away those 4 torx head bastards!!!!
 


Post pics here. Let's share with people what you got and how it's going to be installed. That way if it comes up again.. there's a thread
 
Thats all u had to say billy.. lmao this is my harness thats pulled from the junkyard dont mind my silver switch also will like to note the plug that goes into the heater switch was spliced into jy harness somebody cut it and took the plug so its extended a little

cdddd66d34ff1886f9f11ae13d02004b.jpg
 


You grabbed a lot of extra. Pull off the tape and clean up the harness. Keep just the parts you need.

You should end up with one green and one black connector that plug into the heated elements on the seat cover, a connector that looks like a relay connector and connects to the module that will go under the seat, a five pin connector that will go to the switch
From the seat switch connector you will have three wires (gray, black and brown) that should need you to tap them in and solder.
From the module under the seat you will have two wires, a large orange and large black wire that will need to be tapped and soldered.

Hop on it..
 
Jay.. you asked me how to wire this up.

In the past.. when there was no provision in the Bonne for a heated seat. I tapped into the power wires for the power seat.


Then got ignition and dimming near the switch. Both are available close by.
 
You must log in or register to reply here.
Back
Top