• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

What did you do to your Car today?

Status
Not open for further replies.


Bam here ya go. It's in the name of the boat.
FWD: 2011 Sea Ray 190 Sport with a MerCruiser 4.3L Carb TKS


Sent from my HTC6525LVW using Tapatalk
 
Took mine into my work to have the trailing arms replaced (dang things wouldn't budge!) and to get an alignment done. The car drives and feels a lot better now, almost like it never got t-boned in the first place!
 
turns out the starter was dead.

tested for power when the key was turned and it was there. so i took off the starter, jumped it a few times off the car, it seemed to work and not work.

so i took off the solenoid hoping that was bad, but when i powered up the starter its self it wold work/not work, left hooked to power if i tapped the starter it would work.


so installed new starter today.
 


you can still buy all the main parts to rebuild em for like $40, brush kit was like 18, solenoid was 20. i just dont have time to wait for parts to come in.

im old enough to remember when a rebuilt starter was 30 bucks and weighed a ton.
 


Cars leaking brake fluid from somewhere its a slow leak. It said low fluid going up a hill. I just filled it in September or so. So I guess I'll have to figure out where it's coming from
 
Put on a new plow on the Polaris.

i0VHF5I.jpg
 
Cars leaking brake fluid from somewhere its a slow leak. It said low fluid going up a hill. I just filled it in September or so. So I guess I'll have to figure out where it's coming from

See if its wet around your rear calipers. They like to leak there. If so whichever is leaking needs replaced.
 


Checked all my fluid levels. Still got my trans leak I haven't been able to solve in my 2.30 years of owning the car.

Also new oil leak on the oil filter I can't solve. Everything is tight. All the brass fittings are tight as ****. And the opsu is completely tightened down.

Sent from my HTC6525LVW using Tapatalk
 
assholes at the alignment shop some how knocked my brake line loose on the rear caliper, found the inside of my wheel all wet.

being i need to bleed it now, this would be a good time to put my ss rear lines on that have been sitting in my trunk for like 3 years now lol
 
assholes at the alignment shop some how knocked my brake line loose on the rear caliper, found the inside of my wheel all wet.

being i need to bleed it now, this would be a good time to put my ss rear lines on that have been sitting in my trunk for like 3 years now lol

Give to me Scotty.
 
Status
Not open for further replies.
Back
Top