• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Tune after cam install

I've seen a VS activate the P0300 code.

You're not disabling it, you're setting it to not reporting. There's a big difference.
 


The VS cam will set the P0300 code.

Setting the P0300 code to no reporting will completely disable any misfire detection on the scantool. Setting to no mil light is preferable if you don't have scanning emission testing in your area. Ignore any misfires detected below 1500rpm on the scantool.

HTH
 
You must log in or register to reply here.
Back
Top