Hello everyone,
I'm rebuilding my 4T65E transmission and built a tranny bracket which mounts to an engine stand. I posted some pictures for anyone to get some ideas of how to make one. The bracket consists of a 1/4" X 4" plate with a 1-1/2" X 1-1/2" tubing welded on to it. The other plate which mounts to where the rear transaxle mount goes is also a 1/4" X 4" plate also. If anyone needs dimensions, let me know and I'll put some stuff together. It really helps when assembling everything back in the case. Good luck with your tranny builds!
http://www.screencast.com/t/5SwjcE0RI0LO
Terry
I'm rebuilding my 4T65E transmission and built a tranny bracket which mounts to an engine stand. I posted some pictures for anyone to get some ideas of how to make one. The bracket consists of a 1/4" X 4" plate with a 1-1/2" X 1-1/2" tubing welded on to it. The other plate which mounts to where the rear transaxle mount goes is also a 1/4" X 4" plate also. If anyone needs dimensions, let me know and I'll put some stuff together. It really helps when assembling everything back in the case. Good luck with your tranny builds!
http://www.screencast.com/t/5SwjcE0RI0LO
Terry
Last edited:
