• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Speaker Install Question

G

gordster1122

New member
Last edited:


Rear speaker: remove back seat complete. Remove bottom cushion. Remove four bolts along upper edge of rear seat back cushion. Remove two lower bolts and three nuts. Remove "C" pillar trim, one each screw under ABS emblem, then pull towards center of car to release one each clip. You can then remove the package shelf trim. Each speaker is held to the shelf with two clips.

Door speaker: Remove door panel. Pull inside door handle bezel out, it's held in with clips. Remove trim from just under the armrest, pry it gently. Remove one bolt. The rest of the door is held in with clips. Start at the bottom of the door, pry panel away from door. Tweeter is part of door panel. Mid range speaker is held in with four screws.

Door speakers are 6.5" round. Rear speaker is a 6 X 9 oval. If you have a Monsoon system, each rear speaker has two sets of wires. One set goes to the outside speaker and acts as a subwoofer. Both the left and right speaker is on the same amp channel. The other goes to the midrange speaker.

I was not happy with tying both sets of amp outputs together and ended up getting a Pioneer 4 channel amp.
 
Got the rears installed happy finally have two working speakers instead of one :) had to cut off the old connector and just wrap the wires together have to solder them tommorrow
 
You must log in or register to reply here.
Back
Top