• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Solvent tank+SC case = ?

JoRoW99

JoRoW99

New member
I have access to a solvent tank that I am going to put my heads in. Is it okay to put the SC case in there? I assume the grease in the bearings is going to go be useless afterward. Do I need to remove the bearings? If so how do I go about this and putting new grease in?
 


Don't clean the inside of the case. By removing the carbon build up in the compression chamber you'll reduce the sealing of the SC a slight bit. As for the bearings. When I work on a charger, I duct tape over them.

Removal is either done with a blind pilot bearing tool or you drill and tap them under neath and use a grease gun to push them out.

Rotor Bearing Replacement

Tools
yeah001.jpg


Drill and tap the red holes (pic is after greased them and removed)
yeah006.jpg


Thread your NPT pipe in and hook to grease gun
yeah004.jpg

yeah002.jpg


Pump until the bearing pops out.
yeah007.jpg
 
Thanks for the helpful response.

Well see, I just ported it and I sealed of the bearing holes, but there is aluminum dust everywhere. Is there another way to get it off/out?
 
You must log in or register to reply here.
Back
Top