BoostedPontiac
Regal GS Level Member
Since i cant brain today. When pulling the Harmonic Balancer, does a seal need to be replaced or can i just put it back on?
simple question
- Thread starter BoostedPontiac
- Start date
Scottydoggs
Killa Bee
leave the seal, put the balancer back in.
NOOOOOOOOOOOO! Don't do that! You'll let the "magic smoke" out and you'll be forced to buy a minivan.
seriously, Scotty is right. We've all had those "no brain" days. All you MUST do is be sure that the woodruff key on the crankshaft lines up with the slot on the balancer when you go to reinstall, or bad things can happen.
seriously, Scotty is right. We've all had those "no brain" days. All you MUST do is be sure that the woodruff key on the crankshaft lines up with the slot on the balancer when you go to reinstall, or bad things can happen.
BoostedPontiac
Regal GS Level Member
And the bolt size for the HB removal tool is 1/4 by 28 Right?
Scottydoggs
Killa Bee
the bolts for the balancer to the puller. they are metric size is in this thread. http://www.grandprixforums.net/threads/60906-How-to-replace-a-crank-sensor
M6 x 1.00 and 70-75mm
pretty sure i used 55 mm long and they worked well with it in the car. if you cant find them i have a bag here. i had to buy a bag of 25 bolts. no one had them local long enough.
M6 x 1.00 and 70-75mm
pretty sure i used 55 mm long and they worked well with it in the car. if you cant find them i have a bag here. i had to buy a bag of 25 bolts. no one had them local long enough.
BoostedPontiac
Regal GS Level Member
Ok cool thank you. Ill stop by my local menards and pick up a couple.
Scottydoggs
Killa Bee
you need 3 of them and some washers to keep the heads from pulling through the puller.