• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Serious problem codes and freeze frame

kyleinkman

kyleinkman

New member
Hey everyone lately my 03 GTP has been chugging at idle ( drops from like 900 rmp to 700 rmp) it has lost power and feels like it is dieing or atleast i feel like dieing right now. been noticing a slight sent of gas too, ive already replaced vaccuum lines and inspected what i can see of the gas lines for leaks ect any ideas what could be causing this evil error?
a few side notes im running a 02 simulator on the sensor 1 bank 2 and i have no egr or cat.




p0134- 02 sensor bank1 no activity detected
0403 egr control circuit
0405 egr sensor a circuit low
p1571 invalid trac control signal detected


Fuel system 1 status OL-Fault
Calculated load val 0.00
engine coolant temp 98.00
short term fuel trim bank 1 0.00
long term fuel trim bank 1 0.00
Intake manifold absolute pressure 102.kpa
Engine Rpm 0.00
ai flow rate from maf 1.61 g/s
absolute throttle position 0.00-0.39
bank 1 sensor 1 v 0.47
bank 1 sensor 1 % 0
bank 1 sensor two .68 .80.88.84 .77 .06 .59 .23 .80 .14 .67 .81 .87
 


get a tune man, running a 3.4 pulley on the stock fuel tables is just asking for trouble.

Along with a bunch of other things. The tune can delete those codes and help your car out big time.
 


ok cool so just getting a tuned pcm from overkill? or do you mean getting a dyno? because thats gonna be hard here..
 
Awesome job on listing out the codes and info. Thank you very much.

P0134 is no activity on bank 1 sensor 1. That's the front aka upstream O2 that reads all the engines activity and allows the pcm to control fueling. I'd check that sensor and replace it.

Fuel system 1 status OL-Fault: This means the system is faulted to open loop running, which by default is meant to run the car on the rich side.

It would help if you got a pcm that was tuned for the EGR being deleted. Also it would help if you tracked down which part of the traction control system was bad
 


also seeing the MAP at 102 KPa that means there is no engine vac.... so the freeze frame is either when the car had not started or the MAP sensor is not seeing any vacuum.
 
You must log in or register to reply here.
Back
Top