• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Running 2002 GTP w/o cat = bad MPG???

M

motoshrump

New member
Hey there, This past summer the catalytic converter 1st stage fell apart and plugged the 2nd stage section on my 2002 GTP which prompted me in deleting the cat. Prior to the cat failure the car ran good with decent mileage (approx 25 mpg). Since then I have changed the plugs out for Autolite copper 606's side gapped to 0.050" as well as NGK oem replacement wires. Now under the same driving conditions of 50/50 highway & city I am only getting 17 mpg. My question is if I need to run an O2 emulator in order to improve the mileage. My scan tool shows that the Catalyst Efficiency code comes in repeatedly every 100 miles approximately. Anyone out there experience these symptoms?? Any feedback is much appreciated,

Thanks in advance, Jeremy
 


Yes you will keep throwin codes unless you get a o2 sim or you get your pcm tuned to read no report for the o2 sensor. I cant imagine it hurtin your mpg that bad tho, but someone correct me if im wrong but i thought the plugs were suppose to be gapped to .055-.060 for stock plugs. And depends on how your driving it, if your flooring from one redlight to the next then you should expect mpg like that. I have a 98 with no cat, egr, or o2 and i still get 31 on the interstate and about 23 in town
 
Jeremy...since your car is a '01+ car your only option is to leave the rear o2 and have the code set to no report...they '01+ cars NEED a rear o2 to run correctly.
 
The rear O2 issue is hit and miss on the 01+ cars. Most of the time it's easier to leave the rear sensor in, and set the code to not report, but leave the diagnostic code turned on so it will read the senor.
 
Ok, so my best option is just to disable the routine O2 sensor reference. How do I go about doing that? As far as driving style goes I rarely go WOT and use the s/c for the few hills along the highway between home and the city. Cruising at speeds of around 65-70 mph. Prior to the cat getting removed MPG's were substantially better even with wore out plugs and wires. The car only has 95,000 miles on it and I run 91 octane fuel. I just refilled the car and it worked out to 18.4 MPG. The onboard computer is saying that I am getting 19.6 MPG.
 


So if the code is set, that means it's reading the rear O2 like it should.

You might have problems someplace else.
 
motoshrump said:
Ok, so my best option is just to disable the routine O2 sensor reference. How do I go about doing that? As far as driving style goes I rarely go WOT and use the s/c for the few hills along the highway between home and the city. Cruising at speeds of around 65-70 mph. Prior to the cat getting removed MPG's were substantially better even with wore out plugs and wires. The car only has 95,000 miles on it and I run 91 octane fuel. I just refilled the car and it worked out to 18.4 MPG. The onboard computer is saying that I am getting 19.6 MPG.
Click to expand...

Vacuum leak? Have you check for any of those? Might have some dry rotted "T" fittings around the S/C, LIM, Fuel Rails...I'd check those...you get some pretty craptastic MPG's with a vac leak...you can spray some carb cleaner around the engine bay while its idling...if the idle changes and it sucks in the carb cleaner...you might have found your issue ;)
 
Sometimes the vacuum leak is too small to find just by listening to the engine...say a pinhole, or a crack in a line boot won't always make the engine change rpm when you hit it with carb cleaner. The best and true way to tell is with some sort of scanner. The car's sensitive to the slightest changes, so even a leak you can't normally tell is there, you're likely to find by looking at the fuel trims on the scanner. It's so much easier that this is the first thing I do when I start tracing for leaks.
 
Reptile said:
The best and true way to tell is with some sort of scanner. The car's sensitive to the slightest changes, so even a leak you can't normally tell is there, you're likely to find by looking at the fuel trims on the scanner. It's so much easier that this is the first thing I do when I start tracing for leaks.
Click to expand...

What should the fuel trims be at?
 
You must log in or register to reply here.
Back
Top