• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Roller Rocker Installation

RedGrandPrix

RedGrandPrix

New member
When installing roller rockers (and new pushrods), such as Yella Terra or Pro Magnum, is it necessary to rotate each cylinder to TDC? The instructions from YT say to do this, but it is not mentioned elsewhere on other installation webpages. Is there an easy way to do this if it is necessary. Thanks.

Mike
 


i did not move each cylender to TDC. i have not seen an issuies as of yet.

if you wanna move each cylender to TDC you can put a rachet on the crank and turn it over. might be easier if you pull all the spark plugs out before you do this.
 
I never had any issues and I never turned the motor to TDC either.

I did however after everything was installed unbolted the ICM plug and had someone crank the motor over to see if everything was moving fine before putting the VC's back on.
 
You must log in or register to reply here.
Back
Top