• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

rocker moulding removal

B

b dzik

New member
i want to remove the driver's side rocker panel moulding on a 2000 grand prix gt coupe. besides the 4 screws, what has to be done to remove the moulding? thank you.
 


No idea so I checked my Factory service manual. It says:

1. Remove the rocker finish panel to fender screws.
2. Remove the rocker finish panel to rear quarter screws.
3. Use a heat gun 6 inches from the surface to heat the molding.
4. Hold the heat gun approximately 6 inches from the surface.
5. Apply the heat for approximately 30 seconds using a circular motion.
6. Use a small plastic flat-bladed tool to remove the rocker finish panel from the panel surface.
7. Remove the rocker finish panel from the support panel.
8. Remove the rocker finish panel support nuts from the studs.
9. Remove the rocker finish panel support from the vehicle.
Click to expand...

In reading the installation procedure it appears to be glued to the body:
Push the molding inward to fully seat the molding into the support and ensure a maximum bond of adhesive to body.
Click to expand...
 
You must log in or register to reply here.
Back
Top