• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Rave: valve job

JoRoW99

JoRoW99

New member
So my stepdad knows a guy that works in a performance shop that build big blocks/fast small blocks/ ect. Well anyway I needed a valve job so he came over and took them off to his shop. I got the bill: less than $40 for a valve job! and he even cleaned the gasket surfaces and possibly put them in a hot/solvent tank. I should have had him mill them for a bigger cam since he was so dang cheap. /rave

261496_2031871646701_1541433387_32106362_3645448_n.jpg

267553_2031872046711_1541433387_32106364_4150622_n.jpg
 


Sorry about the rave thing, we have a rant/rave section on my local forum.

slick2500 said:
Wtf is wrong with that one head? It looks like he missed a spot.
Click to expand...

Are you talking about inside the port? that was the farthest my dremel could reach inside haha. I ported these myself.

And yes they are L67 heads.
 


You know you can get extensions for dremmels at menards home depot and lowes right? Just a heads up. Those do look nice tho. Wish I had a good shop in ND to get work done.
 
thanks. If i dont start the swap this weekend i might go pick some up. Its only a little bit in the intake port though, I got all of the exhaust covered, which is where there is the most improvement.

Edit: Actually, probably not. Im not gonna risk nicking the valve seat. Because I know I will.
 
You must log in or register to reply here.
Back
Top