• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

rattle on accelleration

vwthumper

New member
i have a rattle on accelleration and was wandering what you guys might think it would be, doesnt make any noise when at idle but when i accelerate i can hear a rattle,,, if this is the valves is there an easy fix to this ?
 


could be loose exhaust component ( pipe off hanger,heat shield etc..)
can you record the sound so we can hear it
 
because it might be causing your vibration during accel. did this occur before you lowered the car?

lowering the car offsets the axle geometry which in turn causes a vibration.
 


you can either shorten your dogbones about 3/4" or put in some spacers that go underneath the mounts for the trans and motor to raise it up a little. the spacers are a little bit more work, but most likely the best solution.

you just have to make sure that is it. is it misfiring or anything? is it strictly accel in the starting of driving, around 20-35 or so? gets worse the harder you pedal it for a short time?

i kind of need more information. is it just a dash rattle? or does the car shake?
 
the vibration i can see that with it being lowered,, now, the rattle i hear is when i push the gas ,,,if i am going down the road and just push the gas you can hear the rattle ,, you do not hear anything at idle but when u push the gas at take off or if you press the gas to pick up speed you here the rattle and no there are no misfires or anything like that
 
well, if its just a rattle and the car doesnt physically shake then it might not be a suspension problem. something loose in the interior?
 
no no u must have misunderstood,,,, the vibration is seperate from the rattle,, now i am assuming with the car being lowered that is my vibration problem,,,, no the rattle is when i push the gas at anytime either when i takeoff or accelerate on the hwy ,,, no misfires no ticking or rattle noises if the car is in park and idling
 


.Possible flexplate issue? Remove your flexplate cover, rotate it to make sure it isn't cracked. Check the bolts also. Is it a metallic rattle or more like a ticking? A bad flex joint can cause a ticking sound when accelerating.
 
its a 2000 gtp 140,000 miles 3.4 pulley,3'' downpipe,zz performance intake,eibach lowering springs, raven performance exhaust.
 


the tranny changes gears fine there is no problem with shifting or slipping or anything of that nature,,are you talking about the rattle?
 
Back
Top