• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Rad question

F

flipzat

New member
hey i just installed a new rad , i dont see any leaks so far except one the temp sensor ( i think thats what it is ). yea i got a steady drip coming from there when i took it from the old one it just had some wire a round it how can i stop the leak would the red gasket maker stuff work ? should i buy a new one ? it still works i mean it read the temp fine but i dont like the drip
 


You can use pipe tape or any color RTV.



My preference is the gray high temp RTV.
 
I have a small pin hole in the plastic top part of my Rad, i can see a small stream pissin out when the car is up to temp, im thinking about using some plastic weld epoxy it can handle 1300PSI and 250+ Temps im hoping it will work, what you guys think?
 
I'm not so sure 1300 psi can come from a hole that big. I would try some JB weld if it's only a pin hole. Just ruff it up real good.
 
ok doing it on lunch, since it takes 15 min to set and i got another 5 hours to go till i leave now woudl be a good time, cross your fingers cant affort a new rad
 


You must log in or register to reply here.
Back
Top