• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

push rods

K

kenconerly

New member
I'm putting my heads back on the motor.. so I'm wondering is what is the correct way of putting the push rods back in. Ans if there is a proper order of tighten them. I need hepl
 


From what I've learned, as long as they go back into the same spot as they came from then you should be fine. I always get a piece of cardboard and label them as I take them out and push them into the cardboard to keep them in order. FYI, the rocker bolts are TTY and not reuseable, so hopefully you have new bolts for those and also know what rocker goes where if you removed them from the head completely. These motors don't need lash adjustments like older pushrod motors, so just tighten the rockers to the specs 1 by 1 and call it good. Hydraulic lifters FTW.
 
Dont forget some assembly lube, better safe than sorry. And just torque to spec with new bolts.

Sent from my Droid
 
You must log in or register to reply here.
Back
Top