• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Projector HID



all i have is the wires that are in that picture and the wires that came with the projectors
 
P1010032.jpg


P1010033.jpg


I did it both ways... The top picture is how it would be if you didn't pull the wires thru (I had already cut the female spade connectores on the the blue/black wires). Then second picture shows I removed the ballast power wire from the rubber plug in the first picture and just connected the directly to the blue/black wire. The plug with the yellow
insulator would get plugged into your ballast.
 


Both my kits - H1 and H7's (for my fogs) were pretty much the same configuration, just a different mount for the type of bulb it was setup for. Could be why mine was so easy... :)
 
Roca


Those spades go into two different Plugs

The Black Spade goes into the BLACK WIRE that is feeding through the Rubber Cone thing and Connected to the Outside of the Frame (Near where the Bulb is.


And the Blue One goes into the Red wire That is Connected to the STOCK BLUB

plug and play too easy
 




I had different projectors. My highs were 9005. The hids would not fit in the lows. I had to sand down the spot for the bulb so they'll fit.
 
You must log in or register to reply here.
Back
Top