• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

post up your audio equipment



I have the Polk Audio db212-2. It's a ported box.
Not my car but it's the box that I have.
425791e4-a0f0-b4cb.jpg
 
Last edited:


I've just finished putting a Pioneer AVH-P2400BT in. I had a XM receiver from my previous ride, and added HD radio to it. (If I'd done just a little more homework, I would have gotten the next level Pioneer that would have had the HD radio built it.) It all pours into the OEM Monsoon amp system.

I've got the Bluetooth mic sitting under the instrument cluster temporarily. I can't make up my mind whether to mount it in the overhead lamp or hack into the On-Star and use its mic.

I'm also looking into getting an XM antenna off a later G6...which mounts on the trunk lid...so that I don't have to worry about the magnetic base of the Pioneer antenna sliding all over the place.

I've got two problems I still need to clear up. I'm getting RAP feedback into the engine's run circuitry. The engine will run with the key off until I open the door. I'm thinking that the GM-01 adapter I got, which has a hookup for the VSS and backup circuits might be back feeding the PCM through the VSS circuit. Since I'm really not planning on GPS for this, the next time I pull the radio, I've gotta hack into that nicely wrapped harness and cut that.

The other issue is some very occasional popping and scratching through the Monsoon amp that I'll hear with the volume of the head unit turned all the way down. I'm going to give ground loop isolators a whirl...but I'm not real hopeful. I've swapped amps and still have the problem, though one amp is a bit better than the other.
 
Im currently still upgrading my system little by little so thats my only project in progress, not sure if these specs was necessary but i posted them anyway.
20121007_031740_Custom.jpg
20121007_032307_Custom.jpg
20121007_032344_Custom.jpg
20121007_032357_Custom.jpg
20121007_032415_Custom.jpg
20121007_032436_Custom.jpg

AMP:

  • 1 Ohm Stable Class D Mono Block Amplifier
  • Low Level Input and Output
  • Frequency Response: 15Hz ~ 270Hz
  • Input Level: 6V~0.2V
  • Variable Subsonic: 10Hz ~ 50Hz
  • Variable Low Pass Filter: 35Hz ~ 250Hz
  • Variable Bass Boost: 0db ~ 9db
  • S/N Ratio: >85
  • THD: 0.1%
  • Remote Gain Controller
  • Two Amplifiers Linkable Connector and Selector
  • Fuse Rating: 60Amps, Linked Fuse Rating: 120 Amps
  • 1500 Watts Max
  • 800 Watts RMS
  • Dimensions (Inches)
  • Height: 2.18
  • Width: 9.13
  • Length: 11.81


SUBS:

  • RMS 400W
  • MAX 600W
  • Impedence (Ohm) 2x4
  • Rdc (Ohm) 1.7
  • Levc mH 1.346
  • Fo Hz 36.2
  • Sd msqM 47.14
  • BL TM 8.624
  • Qms 3.617
  • Qes 0.786
  • Qts 0.645
  • n% 0.222
  • SPL dB 87.5
  • Vas L 37.1
  • Cms uM/N 111.1
  • Mms g 164.8
  • VC Inch 2
  • Mgnt oz 80
  • Xmax ±MM 11
  • F.Range Hz <800
  • MM 150
  • Inch 5.9
  • SPK DISP. L 3.583

 
New to forum hope to post pics soon Once I figure out how but I have a kenwood ddx419 alpine type-r 6 1/2 components all around with custom pods for rear. Two type- r 12 dvc 2 ohm subs ported box. Fosgate amps 400.4 & 800.2. Just purchased additional 800.2 along with 5 farad capacitor which I havent installed yet.
 


Nice job BFF Larry!!! What 18''s?!?! I'm going to forget the "all in the trunk" single sub setup and trade-in my SMD for 2 18''s or 4 15''s!!! What subs are you running?!?
I cut out the 6'' port and doing an 8''... lil better numbers....
303767_3477453467318_932901727_n.jpg
 
Do not use a Cap!!! It is easy to put a HO DR44 alt on! They usually ate on Tahoes and are very common and easily do 300a
Check my sig or my other thread here on HO alt in a Grand Prix

Sent from my Galaxy
 


For some reason I can't post my pics off my phone. Will have to later. Currently have my prix set up for 2 18s walled in the back seat off 2 shok industries 5kws. I will be running team shok 18s this next spring. Ill figure out how to post some pics up as soon as I get home. I have a build log if you hunt through my started threads though until then.
 
your gonna have to use photobucket or an alike website to post pics here, cant wait to see
maverickdog8 said:
For some reason I can't post my pics off my phone. Will have to later. Currently have my prix set up for 2 18s walled in the back seat off 2 shok industries 5kws. I will be running team shok 18s this next spring. Ill figure out how to post some pics up as soon as I get home. I have a build log if you hunt through my started threads though until then.
Click to expand...
 
You must log in or register to reply here.
Back
Top