• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Pillar Pod

Bedwards

Bedwards

New member
I have a 3 gauge pillar pod from ZZP and I have NO clue how to mount it. The metal underneath (side frame) won't accept a screw, it's way too hard. The pod has 3 holes in it, but I have no idea how to secure it. I'm so frustrated. Please help!
 


Go ahead and mock up the pod,take a marker (with a fine tip) mark the holes, next take the pod down, drill holes with a bit thats the same size or a bit smaller than the screws your using.Then mount the pod back up, HAND screw in the new screws (be careful because they crack easy). Hope this helps.
 
qksilver said:
Go ahead and mock up the pod,take a marker (with a fine tip) mark the holes, next take the pod down, drill holes with a bit thats the same size or a bit smaller than the screws your using.Then mount the pod back up, HAND screw in the new screws (be careful because they crack easy). Hope this helps.
Click to expand...

Thanks for the response, but I tried this. I ended up breaking a drill bit the first go-around. Then when I finally got the hole drilled to the right size, the screw would literally mash and ruin the threads. The metal is too hard to screw into.
 


mill_pic10.jpg
 


You must log in or register to reply here.
Back
Top