Picture request, Spyder headlights

[LS1GTP]

I'm trying to put the halogen h1 bulbs back in my spyder halo headlights (in sig), but I can't figure out how the bulb hold down goes back on.

Just take this rubber boot off (it pulls off, wiggle it back and forth. Those 2 wires will be attached, pull them off.



Here is what you should now see, my bulb does not have the hold down on it



Here is one of the points the hold down attaches to



And the other one



I need to figure out how to get this piece back in place




So PLEASE, if you have these halo headlights and a couple minutes, take a picture of this area. A picture just like my second picture would be awesome. I just can't figure out how this hold down goes back in place.

 

[LS1GTP]

Updated with pictures

 

[schollianmj]

gives you an idea how it is put in...



Edit: Ok lets get creative here.... the next directions refer to the pic at the bottom.

the red circle on the wire goes under the screw circled in red...
the blue circled part of the wire gets hooked under the metal tab circled in blue.
the parts of wire circled in purple will apply pressure on teh bulb where the purple lines are.

 

[LS1GTP]

Wow, thank you so much! That helped!

 

[schollianmj]

Glad I could help.

 

[LS1GTP]

Sorry about the deer mod.

 

[schollianmj]

lol!