• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

noob tuner - need some help

JerzNick

JerzNick

SE Level Member
Hey all,

First question - I'm using a 00 GP GT sedan body with a 00 GTP engine/trans...
Everytime I scan my wot's for tuning I get a p1260 code, which is the (fuel pump speed control relay). The GT doesn't have this relay in the under-hood fuse/relay panel.
I set the code to "no error reported" but I'm wondering if there is a way to keep the fuel pump in high speed? I don't know where/if there is even a relay for the speed
control on the GT body... any advice here is greatly appreciated.

Second question - while scanning wot's, my maf table get wacky! I'm trying to get into mid 11's afr on the 7k rpm and higher cells but when I adjust the table it stays in
13-14 afr... no matter what I do! Could this be a fueling issue?

My mods are:
rebuilt and bored block, 3.0 pulley, heads, headers, XP cam, CAI, ported blower/TB/Lim.

Thanks in advance

Edit: Just ordered a Racetronix Hi-flow venturi fuel pump.
Edit #2: afr gets into mid 11's after about 8250k cell.
 
Last edited:


On the code. No error reported and no check mark. Your pump is always in high speed being a GT

I didn't realize you were a GT. That's why the code was kicking. It definately wasn't the pulley
 
My bad bill. Thought I specified a GT model :/

Do you think I should do injectors with the 3.0. I can't seem to get enough fuel during wot scans. I will post pics when I get home.
 


Second question - while scanning wot's, my maf table get wacky! I'm trying to get into mid 11's afr on the 7k rpm and higher cells but when I adjust the table it stays in
13-14 afr... no matter what I do! Could this be a fueling issue?
Click to expand...

This is a part I don't understand, I am still kinda new to tuning, but I am unsure which way you are going at this.

I just left the MAF table 100% stock past 7,000hz and changed my commanded afr to 11.5 and got rid of any adders that would change it. I set PE to 35% re did the timing tables to 16* for the last 3 "cells". Thats just a cut and dry of what I did, there is alot more to it.
 
I was following "starting hp tuners" thread by "theothernick". It primarily focuses on 7k cells and above. Would you be able to send me your tune file so I can look at it? What are your current mods?
 
Haven't changed much. Only idle, fans and maf. Still stuck trying to figure out the maf. I'm upping from a 3.0 to 3.4 and putting in a racetronix fuel pump tomorrow. We'll see if that makes a difference.
 


you should be scanning commanded AFR and throttle position to be able to tell what the PCM is commanding. Your Power enrichment is what tells the motor to start going rich, and that is enabled by a few different things.
 
I watch the tps all the time. As far as commanded AFR, you mean make a histogram or is one already made?
 


Scan this. You probably only have the option to scan one of the PID's.

commandedafr_zpsaf7da665.png
 
You must log in or register to reply here.
Back
Top