• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

New guy from Florida

S

sagillman

New member
Hello from the Florida panhandle, I just bought a 98 GTP (pace car trim). 100 miles after I got it, the supercharger started to rattle. it was not the coupler because I replaced it with the zzp green one, so I tore it apart and it ended up being the rear rotor bearings. Since I was going to replace them I made the decision to tear down the snout and rebuild it to, also I went ahead and ported the inlet and outlet of the supercharger case and powdercoat the case and snout cobalt blue, I can post pics if you guys want to see it. anyways just thought I would start off posting in this forum.
 


Welcome! Couple people on the forums are in the panhandle as well. I frequent Pensacola (GF attends UWF) and we go to the Ft Walton Beach area/Destin when we get the chance.

Love to see some pictures of the S/C.
 
Here is a few pics of the current progress, keep in mind I still have to do the final polishing on the inlet before I press in the rear rotor bearings.




Threaded 1/8' npt to plug coolant passages


 


Thanks, I plan to add headers and a fwi at the same time I put this back on. I'm not sure what I want to do after that, I don't think I want to lower the pulley size until I add water/meth injection or an intercooler.
 
You must log in or register to reply here.
Back
Top