• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Misfire history in Torque Pro.

spazzz

spazzz

New member
Does anybody know how to clear the misfire history in Torque?

I know I did it in the past when I had a bad plug wire. For all my worth I can't figure it out.
I want to clear the bogs of misfires for when I fix the LIM vacuum Tee.
The 04 L32 isn't sounding healthy.

Another quick Torque question.......How long does the vehicle test take to run?
It went through the scanning, then starts refreshing. After 3 refreshes I said F it.
 


When I got the S4 I couldn't remember the pin. Pretty easy or maybe fudged ELM
Plug in the ELM and turn car to on.
Enable bluetooth on phone. Scan for devices and it should recognize the elm device.
It should then ask for the passcode. ... enter 1234...maybe 0000...6789.

Also don't forget to install the GM PIDs

But I'm sure you tried all that biz a hundred times

Slick2500 said:
What vehicle test?
Click to expand...

On the main page .......test results, which starts scanning when you hit it
 
My misfire history resets itself, have you tried clearing the fault codes? That might reset them too. I've never checked the vehicle test, so I'm not sure on that. I think it's the same thing emissions would do, which I think is 100 miles?
 
Booba5185 said:
My misfire history resets itself, have you tried clearing the fault codes? That might reset them too. I've never checked the vehicle test, so I'm not sure on that. I think it's the same thing emissions would do, which I think is 100 miles?
Click to expand...

No fault codes at all.
Clear logs work with current misfires but doesn't do anything with the misfire history.
 


Has there been any fault codes recently or did you disconnect the battery or anything like that recently? That might be why it hasn't passed that test yet. Go ahead and clear the fault codes to see if it resets the misfire history (unless you want to wait a bit longer for the test thing to pass). It could even be that the test thing hasn't passed because of the misfire history. You can also e-mail Ian Haskins (Torque developer) and he'll help you out.
 
Thanks man. Haven't had any codes.
I just checked today because of the rough idle, but ran out of time to resolve the rubber Tee on the LIM.
It's just one of those quirky computer kinda things that eats at you.
 
Hey spazz what BT obd2 adapter do you have i have the cheap elm327 and it aint working at all.
 
spazzz said:
Thanks man. Haven't had any codes.
I just checked today because of the rough idle, but ran out of time to resolve the rubber Tee on the LIM.
It's just one of those quirky computer kinda things that eats at you.
Click to expand...
I know you don't have any codes, lol. Still reset the fault codes and it may reset the misfire history, too.
 


Booba5185 said:
I know you don't have any codes, lol. Still reset the fault codes and it may reset the misfire history, too.
Click to expand...

This Booba5185 has it goin on. Thanks for the suggestions.

Did what you said man and it worked!!
First scanned for codes(didn't have any)....then menu to find clear faults on ECU...cleared it.
Brought up the main page for real time info...scrolled to MF history and they zeroed

Got the VAC line squared away and alls good in wisco....great weather this week
 
You must log in or register to reply here.
Back
Top