94GrandPrixSE
New member
While I was at the dyno I was adjusting my knock attack and decay. I tried to modify the high load decay table, which looks like this on a stock tune.
136 136 23 23 23 23 23 36 36 36 36 36 36 36 36 36 36
No matter what you enter below 256 it automatically sets it to 256.
256 256 256 256 256 256 256 256 256 256 256 256 256 256 256 256 256
In the bottom right hand corner where it tells you the high and lows of the table it says 256 to 62,640. Currently its at 256 and the blips off KR drop of nicely. So my question is why is this? Based on what the Decay table does im at the lowest, so my timing recovers slowest I can set it to. Has anyone else experienced this?
136 136 23 23 23 23 23 36 36 36 36 36 36 36 36 36 36
No matter what you enter below 256 it automatically sets it to 256.
256 256 256 256 256 256 256 256 256 256 256 256 256 256 256 256 256
In the bottom right hand corner where it tells you the high and lows of the table it says 256 to 62,640. Currently its at 256 and the blips off KR drop of nicely. So my question is why is this? Based on what the Decay table does im at the lowest, so my timing recovers slowest I can set it to. Has anyone else experienced this?
