• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

K&N cold air intake installed.

Max Cook said:
944778_3395604426317_73792976_n.jpg

Took me all of 5 minutes to put that together after the parts came in from amazon. It looks fine and likely outperforms any CAI I could try and finagle into that space while costing a total of like $50-60. And it only cost that much because I opted for the bigger KN filter, 4" piping (due to n*/lq4), and fancy aluminum pipe and colour matching coupler. All I did was figure out the lowest angle bend pipe I could get away with, and order that, a coupler and a filter off amazon. It literally fits perfect and the angle and size is perfect.

I used to have a thrasher CAI before I had a northstar and other things and it fit together way worse and looked way worse than my current setup.
Click to expand...

give me a shopping cart full of everything i need then....
 


For Gxp you need 3.25 45degree bend preferably silicone elbow. Then you'll need either a 3inch coupler for maf to pipe filter of your choice 7in. or under 9in is a tight fit but can work. Fr your pcv just take your hose connector and make a hole in the elbow and insert. Done and done.
 


You must log in or register to reply here.
Back
Top