• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

JET performance v force plus

Dustoff

Dustoff

New member
so I bought this programmer and I have a couple questions hopefully someone could shed some light on...

first, when I push the pedal all the way the LCD is reading the TPS is only at 89% not 100%. could this mean I have a vacuum leak or is this normal?

it also reads 56% for the MAP/MAF at WOT... could this also be caused from a leak?

I do know that my EGR is leaking and I bought the block off plate to install just curious as how to do so? do I just pull of the canister and unplug the wires then just block it off? or do I have to disconnect the wires from the source and remove all other parts? is there possibly a write up about this I've searched the forums but cant find anything on it.


Thanks in advance for any info :)
 


TPS should read closer to 99 or 100. Try holding the throttle open with your hand under the hood and see if you get a higher number.
 
You might be able to at the pedal iirc you can't at the TB I think, but you would have to look at it. Also you can pull the intake tube and the screen off the TB and verify its not opening all the way by looking in the TB. Might need a mirror or use the camera on your phone.

Sent from the Milky Way
 


no sir... just went and did another little test and it was reading 89% most the time and some times it would read 80%!! also when it was reading 80% or I have the pedal mashed the e-brake light would come on and after I let of the pedal it would go off. WTF is goin on here?!
 


I am going outside right now to do so! I have done some research on other forums and im seeing a few ppl with the same issue. no one has cleared it up though...
 


You must log in or register to reply here.
Back
Top