• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Installing New PLOG Exhaust Manifold - Help

Yeah when I did my header install ,I just went at the bolts with a breaker bar to break em loose and then took an air ratchet to take em off. I just cut the crossover ones because im lazy, and I just cut the egr out again because I am lazy. Same with the DP bolts and Cat back bolts. Rusty bolts make me use a grinder and just spend the dollar or two on new ones.
 


Quick question.. What is the size of the bold that connects the cross-over pipe the the em? Also, what is the torque spec for the exhaust manifold studs/nuts, and the cross-over pipe?
 
Both times I installed headers only bolts I broke were the bolts on the crossover, and I just used a standard 3/8 drive ratchet to take out the manifold bolts. And both times I reused the bolts.

Sent from A Galaxy Far Far Away........
 
There's no 10mm in what you are going at..
Crossovers are 13mm
Exhaust bolts are 13mm
The bolts/nuts that hold on the engine lift bracket are 13mm
Plugs.. those are the smaller plug socket. (yeah..that's right, I don't know the size..lol)

In the amount of time I've typed to this thread..I could have done the job.

Sorry.. IDK the torque spec, there is a thread for that though. I go tight.. but not bolt snapping tight.
 


You must log in or register to reply here.
Back
Top