• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Installing LS7/Comp OE-R Lifters

T&D does.

2013-04-16_22-15-18_318_zpse97142b9.jpg.html
 


seriously, get the adj pushrod or a dial indicator from harbor freight and measure that sht. Its easy to do and you wont be buying a set of pushrods that may not work. I had an very similar setup(everything the same except xp cam) and i ended up needing 7.00 pushrods. Do it right the first time
 
Just causing headaches by using anything but stock lifters/pushrods unless you're going with a large cam that requires valvetrain mods.
You're not going to make any more power by going with LS 7/OE-R lifters on average xp and smaller type cams...but hey what do I know?
 
LS7 are factory replacements which are more than adequate for his setup. I didnt wanna burst his bubble and tell him that oe-r lifters are garbageeeeee. I had oer and they were noisey as fk. Switched to LS7(stock) and good to go
 
according to the measurements we took and the guidelines stated, i did not have too much preload.
We took measurements 3 times.

You do have a higher post and chat count then me so you are probably right :P
 


You must log in or register to reply here.
Back
Top